If you press the reset button on it for more than seven seconds it will put the modem back to factory default settings. In my own words: Pressing the reset button for three to four seconds. I wounder if it is required that you reboot the modem? As how to do that, New computer OR Bought the parts for a computer and built/assembled it OR last but not least a spare computer. And required of course than one of the NICs is a wired type. Or if the computer does not have two, the ability to add a second one to make your life easier. Sure it would be possible to have only one NIC but of best interest should have at least two. For example of one of those distros that is distros designed for connection sharing is pfSense. In other words turning a normal computer into acting as it was a NAT router.įor that there is pure DIY and distros designed for connection sharing. Or if not a hardware NAT router, there is also this option too.ĭIY NAT router. Ok, odd that did not work - it should of. When connected directly to the Arris SB8200 do you see any IPv4 Address that your is using computer that is not these three important IPv4 Ranges:Ĭlass A Private LAN 10.0.0.0 to 10.255.255.255Ĭlass B Private LAN 172.16.0.0 to 172.31.255.255Ĭlass C Private LAN 192.168.0.0 to 192.168.255.255 #8 Please do not post the full IPv4 Address(es) of your computer is/are, instead answer this next question. For all of the NICs that are enabled, check what their IPv4 Address is. An example of how to check that = (This is for Windows 10) Start -> Settings -> Network & Internet -> Change Adapter Options. #7 Please check what the IPv4 Address(es) on your computer is/are. Note: Pay attention to what the IPv4 Address is. #6 Please check what the public IP Address that you are coming from. #4 If not, resolve that with only the use of the Arris SB8200 and your computer (and of course power supply) #2 Connect your computer to the Arris SB8200. #1 Disconnect your computer from the FiOS G1100. #1 When they said it is gateway, they are talking about the Arris SB8200? Because otherwise no kidding the FiOS G1100 is considered a gateway. According to Arris support, it does not work because it is a gateway. You keep trying to connect, but you can't get an IP address, even with DHCP Server enabled.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |